Emergency Treatment of Drainage Pipe Leakage排水管漏水，首先要查出是否因为管道堵塞而漏水，如果是因为管道堵塞，则疏通了以后就不会漏水，如果是穿孔或者是连接之处漏水，则可用下列方法解决。堵塞如果破裂之处过大，则必须更换新管。
Drainage pipe leakage, first of all, to find out whether the leakage is due to pipe blockage, if it is due to pipe blockage, it will not leak after dredging, if it is perforated or connected to the leakage, you can use the following methods to solve. If the blockage is too large, a new pipe must be replaced.
If the water supply pipe leaks through the hole, because the water pressure of the water supply pipe is generally higher, the treatment method is to replace the new water supply pipe. But in case of inconvenience, temporary methods can be used first. The simplest way is to plug the hole with a pencil lead, wrap the leaking part of the water pipe with a rubber sheet, and tie it with wire. The leaking part can also be wrapped in rubber skin, and then tightened by holding holes.
If drainage runs slowly but cannot be replaced, it may be a problem of blockage of hair. DIY methods are not attractive, but often effective. Use a hanger and straighten it so that you can slide the drainage holes at the curved end. Move it to the shaving position and slowly pull it out of the drain. Clean up the problem of clogging accumulated hair, pour some detergent or similar products into the sewer and wait for 30 minutes to run before hot water flushing and draining. If you don't want to use harsh chemicals, you can also pour soda powder into the sewer, followed by half a cup of white vinegar. Cover the drainage with rags and quickly plug it into the drainage hole. Baking soda and vinegar react, so it's important to keep the discharge holes covered so the contents don't run away. Slowly remove the plug 30 minutes later and pour a gallon of hot water into the sewer to solve the problem of blockage.
1. When the drainage switch of the basin is in the state of ejection and drainage. Hold the pop-up switch in your hand, rotate counterclockwise, and the cover of the switch is screwed off.
2. After screwing it off, rinse it directly with water, or brush it with a small brush.
3. The sewer will also accumulate a lot of hair and other dirty things, and then use small tweezers to hold out the hair and other dirty things accumulated in the sewer. Rinse with water again.
4. Make sure that the water is washed and tighten the cover of the sewer switch clockwise. All is OK.